Ported Fuel Fitting [Archive]

emiller3

02-22-2009, 11:57 AM

When installing a ported fuel rail fitting,are you supposed to change one on each fuel rail or just the one coming from the cp3?

NWTDIESEL

02-22-2009, 08:55 PM

Just put a couple shims in the driver side fuel rail fitting.

hondarider552

02-22-2009, 10:14 PM

Just put a couple shims in the driver side fuel rail fitting.

X2, i used 2 shims on mine.

emiller3

02-22-2009, 10:52 PM

Not the fprv, the input side of the fuel rail.

hondarider552

02-22-2009, 11:23 PM

Not the fprv, the input side of the fuel rail.

Ohh my bad, i read your question too fast ):h

ripmf666

02-23-2009, 01:42 AM

driver side .125 and drill the pass side to .060

emiller3

02-23-2009, 06:36 AM

driver side .125 and drill the pass side to .060

Thanks:Handshake:,would that be 1\8th driver side and 1\16th passenger side?

ripmf666

02-23-2009, 01:26 PM

Driver .125 pass is .060

emiller3

02-23-2009, 06:42 PM

Would those measurements be equilvent to on another?

emiller3

03-09-2009, 06:54 PM

Driller them tis past weekend,going to find out how it works when the engine is back together.Can't wait! :)

MMLMM

03-10-2009, 04:27 PM

.090 driver and .060 pass. is a good combo too :thumb:

emiller3

03-10-2009, 06:14 PM

It is going to be hard to tell the difference when the engine goes back togeher,but aleast it will allready be done.:thumb:

x Madmax Diesel

12-27-2009, 12:11 AM

what size drill bit did you use? I heard 9/64 works fine.. Not sure where to find .125 bits?

edit: figured it out on the calculator, man those are handy lol